Commercial system

Solarban Low-E & High-Performance Insulating Glass

High-performance insulating glass for commercial storefront, curtain wall, and exterior glazing, coordinated with thermal performance and project specifications.

Commercial system
Commercial curtain wall with insulating glass capability reference
Representative capability imagery. Not published as a named Capital Glass project.

System overview

IGU make-up coordinated with the frame

Capital Glass provides high-performance insulating glass solutions for commercial storefront, curtain wall, and exterior glazing applications.

Products such as Vitro Solarban 60, Solarban 70, and Solarban 72 offer different combinations of visible light transmission, solar control, and architectural appearance. Glass selection is coordinated with project specifications, required thermal performance, and the framing system.

Product examples to verify: Vitro Solarban 60; Vitro Solarban 70; Vitro Solarban 72.

01
Coating position Low-E coating surface depends on the product, climate strategy, and approved insulating glass make-up — confirm before publishing performance claims.
02
Appearance and performance Visible light, reflectance, and solar heat gain are balanced with the architect’s aesthetic and energy targets.
03
Framing compatibility Spacer, seal, and glass thickness must match the storefront or curtain-wall system receiving the IGU.

Component overview

Insulating glass unit (IGU) surfaces

Double-pane IGUs use four numbered glass surfaces from exterior to interior. Understanding surface numbering helps general contractors review submittals and Low-E coating location.

In cooling-dominated climates, solar-control Low-E coatings are commonly applied to Surface #2 to reduce solar heat gain while allowing natural daylight into the building.

Double-pane insulating glass unit with glass surfaces 1 through 4 labeled and Surface 2 solar-control coating highlighted
Approved educational concept (Nov 2026). Replace with the high-resolution ChatGPT PNG when available — not a manufacturer-certified installation detail.

Surface #2

Cavity-facing face of the outer lite. In cooling-dominated climates, solar-control Low-E coatings are commonly applied here to reduce solar heat gain while allowing daylight in. This is a typical configuration, not a universal rule — confirm coating position against the Vitro Solarban product data and project specification.

Surface #2 coating shown here is an illustrative example for Houston-area solar control, not a universal Solarban configuration. Validate coating position and glass make-up against Vitro product data and the project specification.

Coordinated with the package

Reviewed as part of the opening.

  • Exterior and interior lite selection
  • Spacer, cavity fill, and edge seal system
  • Coating surface per Vitro product data
  • Submittals aligned with the specified framing system

No specific Solarban performance values or coating positions are published here unless confirmed for your project. The interactive diagram below is educational, not a manufacturer-certified detail.

Discuss insulating glass make-up

Send the façade type, performance targets, and specification section if available. Capital Glass will align glass selection with the framing system and submittal requirements.

Request a bid